Polytrol

Polytrol is a deep penetrating oil that restores the original look and finish to gelcoat, plastic, metal, and other surfaces. It dries to a tough, long-lasting, flexible finish, penetrating deeply to re-wet the pigments and restore color and luster lost through exposure to sunlight, rain, and pollution. On bare metals, Polytrol restores shine and protects against corrosion.

• Restores the color and appearance of dull and faded surfaces
• Revives and enhances the color of faded marble, tombstones, slates, and tiles including terracotta tiles
• Rejuvenates flat and chalky paintwork dulled by weathering
• Eliminates the need for waxes and polishes that dry out quickly
• Restores and protects the shine of polished metals
• Easy to apply and maintain
• Protects against corrosion

General Directions

Surfaces must be clean, dry, and free of dirt, grease, grime, and mildew. All waxes, polishes, and silicone should be completely removed. Treat mildew with a 50/50 bleach/water solution, scrub onto the surface, allow to stand for 10-15 minutes, and rinse thoroughly.

Application Instructions

Always work in areas that can be completed in 10-20 minutes. If the surface absorbs Polytrol unevenly, move surplus oil from shiny areas to matte areas. Wipe off excess Polytrol with a clean lint-free cloth before it becomes tacky. For a shinier finish, buff the surface with a lint-free polishing cloth.

Plastic, Gelcoat, Tiles, Painted Surfaces, etc.:

1. Apply Polytrol liberally and evenly with a brush or cloth.
2. Allow to work for 10-20 minutes.
3. Wipe off excess Polytrol with a clean lint-free cloth.
4. Leave to dry.

Stone, Brick, etc.:

1. Apply Polytrol liberally and evenly with a brush or cloth.
2. Allow to work for 10-20 minutes.
3. Brush out or wipe off excess Polytrol with a clean lint-free cloth.
4. Leave to dry.

Metal:

1. Soak an abrasive pad or wire wool in Polytrol and apply to the surface with a rubbing action.
2. Allow to work for 10-20 minutes.
3. Wipe the surface with a cloth to remove all residue.
4. Buff the surface with a soft, lint-free cloth.
5. Leave to dry.

Note: Polytrol is not a surface coating. Its place is in the surface, not on the surface.

Capacity: 1000ml