Digital ECU Tuner 3

The Digital ECU Tuner 3 is the advanced successor to the popular ECU Tuner 2, engineered for enthusiasts seeking precise and flexible control over engine management. Powered by a high-performance processor and equipped with 8Mb DataFlash memory, the DET3 delivers significantly expanded capabilities for tuning and data logging.

• 4 independent 16x16 maps: fuel map, two PWM maps, ignition map
• 8 correction maps (16x1)
• 2 independent, switchable sets of maps
• Modify a single analog signal
• 4 analog inputs
• Built-in DataFlash for offline logging (no laptop required)
• Power supply voltage measurement
• Signal modification for frequency flow meters (17Hz–4kHz)
• Ignition signal support: inductive, Hall, optical sensors, and ignition module signals; compatible with single-ended and differential signals
• Supports ignition types: 60-2, 36-2, 36-1, Multitooth, Ignition Modules
• Turbocharger/supercharger control valve support
• Controls up to 4 high-resistance injectors (“full group” system)
• Parametric ON/OFF output
• Automatic MAP to MAF conversion with learning algorithm
• Starting procedure and built-in road dyno
• Calibration capability for any analog sensor (display real values: e.g., MAP in bars, wideband in AFR)
• Free firmware upgrades as new features are released
• USB communication
• 24-month warranty

Minimum Hardware Requirements:

• Windows 2000, XP, Vista, or Windows 7
• Screen resolution: at least 1024x768, 16-bit color
• Processor: 600MHz or higher
• USB port

Included in the Set:

• Digital ECU Tuner 3 device
• AA USB cable
• Plug and set of pins
• CD with software, drivers, and user instructions (Polish language)
• Additional set of resistors and rectifying diode for installation

Note: Ecumaster brand products are not shipped to the USA, Canada, or Mexico.